ACPI S1 / S3 etc. expert plz :-)

[Guest RJK]

My "other" PC,

(XP Home ed. SP3, Asrock AliveNF6G/VSTA/M/ASR|x2 6000 cpu | 2x1gb OCZ PC2

200mhz 4-4-4-12),

 

....I chose Standby, and, (unlike putting my "main" PC in standby, where hd's

power down but, psu and fans keep running), after just a couple of seconds

it powered almost right down ! ...much like "hibernate" but, without the

hiberfil.sys progress bar as the RAM snapshot is written to hard disk.

Obviously RAM contents are maintained in this "Standby" state...

 

It would only awake from that 'Standby' state by a mouse left-click, (which

is fine), but, LAN connection to router would not recover until a reboot.

I checked to make sure that "Allow this device to power off..." is

"un-ticked" for the LAN connection.

 

Any idea why LAN connection goes to "Limited Connectivity" or fails to

recover after coming back from "Standby," and is there any way to fix that

? ..."disabling" and restarting LAN connection doesn't work - it has to be

rebooted.

 

It would be nice for my main PC to seemingly power almost right down as well

but, a bit pointless if they both have to be rebooted to get their LAN

connections working again !

 

Any tips appreciated,

 

TIA

 

regards, Richard

[Guest RJK]

Re: ACPI S1 / S3 etc. expert plz :-)

 

Ooops, silly me ...forget that plz,

....all I have to do is "disable" LAN connection, then Standby,

.....then after coming out of Standby, ..start up the LAN connection :-)

 

....the obvious is walways overloooked, ..(by me at least) !

 

regards, Richard

 

 

"RJK" <notatospam@hotmail.com> wrote in message

news:OgsQSiCOJHA.1744@TK2MSFTNGP06.phx.gbl...

> My "other" PC,

> (XP Home ed. SP3, Asrock AliveNF6G/VSTA/M/ASR|x2 6000 cpu | 2x1gb OCZ PC2

> 200mhz 4-4-4-12),

>

> ...I chose Standby, and, (unlike putting my "main" PC in standby, where

> hd's power down but, psu and fans keep running), after just a couple of

> seconds it powered almost right down ! ...much like "hibernate" but,

> without the hiberfil.sys progress bar as the RAM snapshot is written to

> hard disk. Obviously RAM contents are maintained in this "Standby"

> state...

>

> It would only awake from that 'Standby' state by a mouse left-click,

> (which is fine), but, LAN connection to router would not recover until a

> reboot. I checked to make sure that "Allow this device to power off..."

> is "un-ticked" for the LAN connection.

>

> Any idea why LAN connection goes to "Limited Connectivity" or fails to

> recover after coming back from "Standby," and is there any way to fix

> that ? ..."disabling" and restarting LAN connection doesn't work - it has

> to be rebooted.

>

> It would be nice for my main PC to seemingly power almost right down as

> well but, a bit pointless if they both have to be rebooted to get their

> LAN connections working again !

>

> Any tips appreciated,

>

> TIA

>

> regards, Richard

>