Guest Cindy B Posted July 25, 2007 Posted July 25, 2007 Hi - I am setting up a new server (winodws 2003 R2) and am in the process of doing the data migration - However - when I change the map drives to the new server. It is hanging onto the old paths. I found a solution to that by adding a net use P: /delete at the beginning of the script, then mapping the drive correctly. It works EXCEPT... it then throws in a Z:\\oldserver\oldpath drive??? I can't figure out where it is getting that from or how to get rid of it??? - Any help would be appreciated!!!! thanks in advance for your time!!!! -- Cindy B
Guest Robert L [MVP - Networking] Posted July 26, 2007 Posted July 26, 2007 Re: mapped drive problem You may try net use * /d. Bob Lin, MS-MVP, MCSE & CNE Networking, Internet, Routing, VPN Troubleshooting on http://www.ChicagoTech.net How to Setup Windows, Network, VPN & Remote Access on http://www.HowToNetworking.com "Cindy B" <benedett@brainerd.net> wrote in message news:31B53AD9-8373-4264-8DDD-CAA1C53A9A3A@microsoft.com... Hi - I am setting up a new server (winodws 2003 R2) and am in the process of doing the data migration - However - when I change the map drives to the new server. It is hanging onto the old paths. I found a solution to that by adding a net use P: /delete at the beginning of the script, then mapping the drive correctly. It works EXCEPT... it then throws in a Z:\\oldserver\oldpath drive??? I can't figure out where it is getting that from or how to get rid of it??? - Any help would be appreciated!!!! thanks in advance for your time!!!! -- Cindy B
Recommended Posts