Jump to content

CD Drive N:\ is not accessable,nor available,doesn't respond nor E


Recommended Posts

Posted

Hi

I've got an old PC (HP Pavilion 8756C) with Windows XP Pro, installed on top

of Windows ME 7 years ago. It's been kept in great shape. I never had a

serious problem with it until last week when I noticed that one of the CD

Drives is not loading up right as follows:

* When I start/restart Windows, all basic programs load up exept for one:

CD Drive N:\ [the secondary CD Drive] -most of the time- doesn not. Its not

being recognized as a system disk (Meaning, when I go to My Computer, Its not

there), I only see: LOCAL DISK (C:), CD Drive M:\ , and the 3½ Floppy (A:) .

And, when it does load up, it could be seen on: 'My Computer' but, it either

causes my PC to 100% jammmed untill I shut it off, ( that happened 95 times

out of every 100 times I reboot my machine) or it wont be accessable, nor

available in many cases with many different error messages, and most of all

it wont eject (open and close). I tried in Safe Mode and I also tried a 'one

month old' good system Restore point. I checked the Volume for errors, I

defragmented Hard Disk twice, I also did SFC Scannow & Windows FileProtect.

Nothing of the above brought any good results. I also did all kind of

checking and searching for viruses, spyware or bugs,, nothing of that was

found. I also checked the hardware itself from the inside and made sure its

and all related wires are connected and plugged in good. Like I said, it only

loads up (without causing my system to jam) like 5 time out of every 100

times I reboot. In those good times It works perfect as used to, it gets

accessable, available, playable 'CDs and suff', and it could eject (open and

close). I know its tricky & funny, its not a one way problem to be diagnosed

and dealt with the right way.

 

CD Drive M:\ uses (MITSUMI CR 4804TE DVD/CD-Rom Drives) . I've got no

problem what so ever with CD Drive M:\. CD Drive N:\ uses (SAMSUNG CD-ROM

CS-148 DVD/CD-Rom Drives). I did Uninstall then Reinstall the driver.. I also

tried to see if there was an update for it, but unfortunately there was none

out there. I tried to trouble shooting the driver, but for some reason the

Trouble Shooting Wizard wouldn't start..

My Computer Bios Revision is : 2.05 09/12/00 ,, I know its kind of old, but

I don't know if a bios update is needed (anyway I couldn't find any Bios

update in HP site for it, but again under what O/S to look for that Bios

Update, XP or ME) and I don't know if a bios board cmos faulty setup can

cause CD Drive N:\ to fail everytime I reboot and not to start ide setting

between Master and Slave or none Master Drives parameters. I think I was

suposed to get a Bios update more than 7 years ago when I had Windows ME and

before I install Windows XP Pro on top of it, but I never did.

By checking my Computer System /PhoenixBios setup utility, I concluded that

the Bios theory isn't the case.. but I noticed that one item doesn't look

right!! where it shows that:

Installed O/S is : Win 98/ Win 2000 !!!!! It's weird !!!!! I've never had

either one of those,, so I don't know what to say here.. and if I should

correct that (and how?) or should I reset it to its original default

settings, under Windows ME !!! or the current Version Windows XP Pro?? I

don't know.

Well that's all,, I think its too much for me to say and for You to read...

 

I also took and uploaded some photos showing parts of the problem .. if

You're interested and have an other minute to spare, please go here, download

the zipped /photos file and tell me what You think, if You will :

 

http://www.freewebs.com/netzzz/CD%20Drive%20%28N%29%20%20Errors%20Photos.zip

 

thanking You for your Time and your Help..

 

Remay

  • Replies 1
  • Created
  • Last Reply

Popular Days

Guest CreateWindow
Posted

Re: CD Drive N:\ is not accessable,nor available,doesn't respond nor E

 

Hi Remay,

 

Could be the CD is aging. Can you try another CD drive? Also the main PC

motherboard and or power supply may be aging. I know that sounds weird for

modern electronics, however there are components called Electrolytic

Capacitors that "dry out" in a 7 yo system. Especially if its a PC that has

done a lot of work and has been hot.

 

One system check you could try is opening a command prompt and issuing the

command chkdsk /r (hit enter and say "Y" to check it next re-boot).

 

This will fully check and repair the hard disk on the next re-boot.

 

Hope that helps.

 

CreateWindow

 

http://mymessagetaker.com

The While-You-Were-Out program you always wanted.

Stop using those paper phone message pads

make the computer work for you.

 

 

 

 

"Remay" <Remay@remember.Live.Love> wrote in message

news:A596AADC-EB49-44C5-9088-592DBFE9D21E@microsoft.com...

> Hi

> I've got an old PC (HP Pavilion 8756C) with Windows XP Pro, installed on

> top

> of Windows ME 7 years ago. It's been kept in great shape. I never had a

> serious problem with it until last week when I noticed that one of the CD

> Drives is not loading up right as follows:

> * When I start/restart Windows, all basic programs load up exept for one:

> CD Drive N:\ [the secondary CD Drive] -most of the time- doesn not. Its

> not

> being recognized as a system disk (Meaning, when I go to My Computer, Its

> not

> there), I only see: LOCAL DISK (C:), CD Drive M:\ , and the 3½ Floppy

> (A:) .

> And, when it does load up, it could be seen on: 'My Computer' but, it

> either

> causes my PC to 100% jammmed untill I shut it off, ( that happened 95

> times

> out of every 100 times I reboot my machine) or it wont be accessable, nor

> available in many cases with many different error messages, and most of

> all

> it wont eject (open and close). I tried in Safe Mode and I also tried a

> 'one

> month old' good system Restore point. I checked the Volume for errors, I

> defragmented Hard Disk twice, I also did SFC Scannow & Windows

> FileProtect.

> Nothing of the above brought any good results. I also did all kind of

> checking and searching for viruses, spyware or bugs,, nothing of that was

> found. I also checked the hardware itself from the inside and made sure

> its

> and all related wires are connected and plugged in good. Like I said, it

> only

> loads up (without causing my system to jam) like 5 time out of every 100

> times I reboot. In those good times It works perfect as used to, it gets

> accessable, available, playable 'CDs and suff', and it could eject (open

> and

> close). I know its tricky & funny, its not a one way problem to be

> diagnosed

> and dealt with the right way.

>

> CD Drive M:\ uses (MITSUMI CR 4804TE DVD/CD-Rom Drives) . I've got no

> problem what so ever with CD Drive M:\. CD Drive N:\ uses (SAMSUNG CD-ROM

> CS-148 DVD/CD-Rom Drives). I did Uninstall then Reinstall the driver.. I

> also

> tried to see if there was an update for it, but unfortunately there was

> none

> out there. I tried to trouble shooting the driver, but for some reason the

> Trouble Shooting Wizard wouldn't start..

> My Computer Bios Revision is : 2.05 09/12/00 ,, I know its kind of old,

> but

> I don't know if a bios update is needed (anyway I couldn't find any Bios

> update in HP site for it, but again under what O/S to look for that Bios

> Update, XP or ME) and I don't know if a bios board cmos faulty setup can

> cause CD Drive N:\ to fail everytime I reboot and not to start ide setting

> between Master and Slave or none Master Drives parameters. I think I was

> suposed to get a Bios update more than 7 years ago when I had Windows ME

> and

> before I install Windows XP Pro on top of it, but I never did.

> By checking my Computer System /PhoenixBios setup utility, I concluded

> that

> the Bios theory isn't the case.. but I noticed that one item doesn't look

> right!! where it shows that:

> Installed O/S is : Win 98/ Win 2000 !!!!! It's weird !!!!! I've never

> had

> either one of those,, so I don't know what to say here.. and if I should

> correct that (and how?) or should I reset it to its original default

> settings, under Windows ME !!! or the current Version Windows XP Pro?? I

> don't know.

> Well that's all,, I think its too much for me to say and for You to

> read...

>

> I also took and uploaded some photos showing parts of the problem .. if

> You're interested and have an other minute to spare, please go here,

> download

> the zipped /photos file and tell me what You think, if You will :

>

> http://www.freewebs.com/netzzz/CD%20Drive%20%28N%29%20%20Errors%20Photos.zip

>

> thanking You for your Time and your Help..

>

> Remay

>


×
×
  • Create New...