Guest Josh - DSTECH Posted May 13, 2008 Posted May 13, 2008 Good morning all, I have been having issues with a 2003 Server R2 with SP2 for about a month now. It is the lone domain controller in a single-server environment with less than 20 user accounts/client PCs. About once a week AD seems to stop responding completely. After a reboot everything comes back up fine and works again for approximately a week. During the down time I get Event IDs of 4000 and 9999 repeatedly in my DNS Server log as well as Userenv - 1053 repeatedly in the Application log. If I attempt to open ADUC I get an error of "The server is not operational". dcdiag comes back with the following: Domain Controller Diagnosis Performing initial setup: [FILESERVER1] LDAP search failed with error 58, The specified server cannot perform the requested operation.. **Error: The machine, FILESERVER1 could not be contacted, because of a bad net response. Check to make sure that this machine is a Domain Controller. After a reboot, all errors in Event Viewer discontinue and dcdiag comes back with everything OK. Any ideas would be very much appreciated. Thanks! -- Josh M DSTECH Inc.
Guest Meinolf Weber Posted May 14, 2008 Posted May 14, 2008 Re: 2003 Server R2 SP2 AD problems Hello Josh, See your posting in AD NG. Best regards Meinolf Weber Disclaimer: This posting is provided "AS IS" with no warranties, and confers no rights. ** Please do NOT email, only reply to Newsgroups ** HELP us help YOU!!! http://www.blakjak.demon.co.uk/mul_crss.htm > Good morning all, > > I have been having issues with a 2003 Server R2 with SP2 for about a > month now. It is the lone domain controller in a single-server > environment with less than 20 user accounts/client PCs. About once a > week AD seems to stop responding completely. After a reboot > everything comes back up fine and works again for approximately a > week. During the down time I get Event IDs of 4000 and 9999 > repeatedly in my DNS Server log as well as Userenv - 1053 repeatedly > in the Application log. If I attempt to open ADUC I get an error of > "The server is not operational". dcdiag comes back with the > following: > > Domain Controller Diagnosis > > Performing initial setup: > [FILESERVER1] LDAP search failed with error 58, > The specified server cannot perform the requested operation.. > **Error: The machine, FILESERVER1 could not be contacted, because > of a > bad > net response. Check to make sure that this machine is a Domain > Controller. > After a reboot, all errors in Event Viewer discontinue and dcdiag > comes back with everything OK. Any ideas would be very much > appreciated. Thanks! > > -- > Josh M > DSTECH Inc.
Recommended Posts