install but cannot boot up win2000 using ich9do

[Guest aclhkaclhk]

I have a motherboard, gigabyte (ga-q35-s2) using this controller:

 

Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE

Controller (rev 02)

 

harddisk: 320G, sata2

 

formating and copying files to harddisk are ok but after reboot:

 

invalid boot.ini

booting from c:\winnt

ntdetect failed

 

Pls kindly advise.

[Guest Dave Patrick]

Re: install but cannot boot up win2000 using ich9do

 

You'll need to start over.

 

http://www.intel.com/support/chipsets/imsm/sb/CS-021736.htm

 

 

 

--

 

Regards,

 

Dave Patrick ....Please no email replies - reply in newsgroup.

Microsoft Certified Professional

Microsoft MVP [Windows]

http://www.microsoft.com/protect

 

"aclhkaclhk" wrote:

>I have a motherboard, gigabyte (ga-q35-s2) using this controller:

>

> Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE

> Controller (rev 02)

>

> harddisk: 320G, sata2

>

> formating and copying files to harddisk are ok but after reboot:

>

> invalid boot.ini

> booting from c:\winnt

> ntdetect failed

>

> Pls kindly advise.

[Guest Dave Patrick]

Re: install but cannot boot up win2000 using ich9do

 

Forgot the link.

 

http://downloadcenter.intel.com/Detail_Desc.aspx?agr=Y&ProductID=2101&DwnldID=10611&strOSs=19&OSFullName=Windows*%202000&lang=eng

 

--

 

Regards,

 

Dave Patrick ....Please no email replies - reply in newsgroup.

Microsoft Certified Professional

Microsoft MVP [Windows]

http://www.microsoft.com/protect

[Guest Andy]

Re: install but cannot boot up win2000 using ich9do

 

On Mon, 21 Jan 2008 02:42:17 -0800 (PST), aclhkaclhk

<access_you@yahoo.com> wrote:

>I have a motherboard, gigabyte (ga-q35-s2) using this controller:

>

> Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE

>Controller (rev 02)

>

>harddisk: 320G, sata2

>

>formating and copying files to harddisk are ok but after reboot:

>

>invalid boot.ini

>booting from c:\winnt

>ntdetect failed

>

>Pls kindly advise.

You have to provide more details as to what steps you have taken

during Windows setup.

In bios setup what is SATA Port0-3 Native Mode (Intel ICH9DO

Southbridge) set to?

I'm assuming the partition you're installing to is 128G or smaller?